Raised Fit Retractable Tie-Down Anchors | ’00-13 Toyota Tundra | Regular Cab | Double Cab | (#9001)

Raised Fit Retractable Tie-Down Anchors | 2000-2013 Toyota Tundra | Regular Cab | Double Cab | (#9001)

Bullrings are the premium tie-down anchor point for your truck. While the stock anchors points are inside the bed where it’s hard to reach, Bullrings retractable anchor points easily install into the stake pockets on top of your bed rails. Each is made from stainless steel for a 1000 lbs capacity, matches the grain and color of Toyota rail caps, and comes with our “no bull” Lifetime Warranty. Simply pop the stainless steel anchor ring up when you want to use it to secure a load, then hit it down flush when you don’t.

Our classic Raised model sits just above the rail cap. Works with truck models that have pop-out rail cap covers. Sold as a pair. Installation is quick and easy and requires nothing more than a Phillips head screwdriver. The typical install time is 30 seconds to 1 minute.

Bullrings are essential Toyota pickup truck accessories. Can be installed in the 4 stake pockets of your Toyota truck to get the most out of your tie-down anchors. Purchase 1 pair or 2 pairs to fit those slots.

• Front – 6.5′, 8′ Bed (9001)
• Rear – 6.5′, 8′ Bed (9001)

Installation

Tundra Access Cab and Double Cab Models  –

• • Installation is quick and easy, and requires nothing more than a Phillips head screwdriver. Remove any plastic cap that covers the stake pocket. Use a Philips screwdriver to loosen the two screws in the anchor, so that the steel plate drops down. Place the anchor into the stake pocket at an angle. Pull the anchor ring up, so that the steel plate catches on the metal rail cap below, and tighten down the Phillips screws until they are hand tight (if the plastic railcap is starting to bending/bowing – then it’s too tight). Typical install time – Under a minute.

*Does NOT Fit Crew Max models (with 4 Full Doors).